Standard Features :
Self-Canceling Turn Signals
8-Position Tilt
4-Way Flashers
Ford Style Knobs and Levers
Ford Turn Signal Switch
Ford Top Shaft
Floor Mount included
3/4" 36 Lower Shaft
Collapsible
Available Finishes: Paintable Steel, Chrome Plated Steel, Black Powder Coated
Steering Wheel Adaptor Bolt Patterns Available: Ford Top Spline

Note: A stock Ford wheel will bolt on the top this column.

TECH TIP: When installing your stock steering wheel to your ididit Ford Style Retrofit Column, the OEM wheel must be for the same year application as the column (i.e. 1968 Mustang Wheel used with 1968 ididit Ford Style Column). Use of a different year WILL result in damage to the turn signal switch.

Installation Kit
Part numbers
Installation Instructions
Mustang Flyer

1968-69 Mustang Paintable Steel
Tilt Floor Shift - 1968: 1300644010 1969: 1300646010

Part numbers

Note: A stock Ford wheel will bolt to the top of this column.

This retrofit column is designed to fit your Mustang. ididit's Ford Style column features all Ford wiring and a Ford top shaft and will bolt to your stock box or rack & pinion system. To install, simply remove your old column, saving your original underdash mount. A new floor mount is included with this column as well as Ford style knobs & levers and male & female plugs with terminals. For your safety, the 1968 and 1969 columns are fully collapsible. ididit's Mustang column will accept a stock Mustang steering wheel (see above tech tip) or an aftermarket wheel with an adaptor.  By using the stock underdash mount and a new coupler, the installation is a breeze!  This 8-position tilt 1968 and 1969 Mustang column is available in Paintable Steel, Chrome and Black Powder Coated.  As always, all ididit  columns are American Made!

Part numbers...

1968 Power or Manual Stock Box 3006002100 Kit includes 3/4”36x 3/4” DD Coupler, 2 5/16 DD Shaft & 3/4” DD x 3/4” 36 Rag Joint

1969: Power or Manual Stock Box 3000053434 Kit includes 3/4” 36x 3/4” 36 Rag Joint

1968-69: Rack & Pinion* 3000013449 3/4”DD x 3/4”36 U-Joint, 3000409418 18” DD Shaft. Manual Rack will also need a 3/4” 36 x ? U-Joint (? = depends on manufacturers output shaft). Power Rack will also need a 3/4”36 x ? Vibration Joint (? = depends on manufacturers output shaft).

*Note: If you are using a Rack and Pinion set up you will have to design your own way to hook the column to the rack. We can help with U-Joints and shafting, but because of headers and different companies making rack kits we will need more information for you to get you the correct installation kit.

(Installation Kits are sold separately) .

Rag Joint