Mon - Fri 8:00am - 6:00pm ET

(517) 424 - 0577

100% American Made!
Blog

Neutral Safety Switch Wiring

NeutralSafetySwitch_w1-2arrows

1- The two tabs on the right side of the Neutral Safety Switch (NSS) control the actual starting of the engine. Hook the solenoid wire from the ignition switch to the top tab on the right side of the NSS. Connect a wire from the bottom tab to the starter solenoid marked with the letter “S.”

2- The other two tabs are for back-up lights. One tab goes to a fuse that is hot all the time. The other tab goes to the back-up lights. If no back-up lights are to be used, disregard these directions and do not hook any wires to either tab.

Please Note: The NSS has been pre-adjusted. If you remove the switch to paint the column, you may have to adjust it so it will only start in park and neutral again.

This entry was posted in Tech Tip Tuesdays and tagged , , , . Bookmark the permalink. Follow any comments here with the RSS feed for this post. Post a comment or leave a trackback: Trackback URL.

Post a Comment

You must be logged in to post a comment.